Bowie, TX
Whether your system has reached the end of its life or you're upgrading for efficiency, we size and install AC systems to actually perform the way they're rated to. Locally owned and operated.
If any of these sound familiar, it's worth having someone take a look.
A system that needs service multiple times a season is signaling it's reaching the end of its useful life.
Most central air conditioners are designed for roughly 10-15 years of service; efficiency and reliability both decline well before that end point.
Aging equipment loses efficiency gradually, and a system nearing failure often runs longer to reach the same setpoint.
Can point to a system that was undersized (or oversized) for the home from the start.
A compressor working harder than it should is often a sign the equipment is struggling, not just aging cosmetically.
Older systems designed around discontinued refrigerants become harder and more expensive to service as supply shrinks.
A system that's the wrong size for the space often cools the air quickly without adequately removing humidity.
An air conditioner that's too large for the space cools the air quickly and shuts off before it has time to remove humidity, leaving the home cold but clammy. One that's too small runs constantly and still can't keep up on the hottest days. Correct sizing comes from a room-by-room load calculation — square footage, insulation, window area, orientation — not a rule of thumb based on the old unit.
Efficiency ratings are also tested as matched systems: a given SEER2 rating assumes a specific indoor coil paired with a specific outdoor unit. Mixing a new condenser with an old coil is a common way to install a high-efficiency unit and never see the efficiency gain on the bill.
Sizing off the old unit's tonnage instead of a proper room-by-room load calculation is one of the most common install mistakes — it carries forward whatever was wrong with the original sizing.
Pairing a new outdoor unit with an old indoor coil forfeits the rated efficiency of the new equipment; manufacturers rate systems as matched pairs.
A new system connected to leaky or undersized ducts will underperform regardless of how good the equipment itself is.
Moisture or air left in the line set is a leading cause of early compressor failure.
New equipment can draw a different load than the old unit; breaker and disconnect sizing needs to be checked, not assumed.
We look at what's going on and explain what we find before any work begins.
We walk through the options and give you an honest recommendation for your situation.
The job gets done thoroughly and professionally.
You see the results before we leave, and we answer any questions.
Every job is different. These are the things that move the number up or down.
It comes from a load calculation based on the home's square footage, insulation, windows, and layout — not just matching the old unit's tonnage.
A straightforward like-for-like replacement is often a single day. Ductwork or electrical work extends that.
Pairing new and old components sacrifices the rated efficiency of the new equipment. A matched indoor/outdoor set performs as designed.
Contact us and we'll take a look at what you need. Quotes are free.
Fast, thorough air conditioning repair for homes and businesses in Bowie and Montague County.
Learn more →Furnace and heating system repair to get your home back up to temperature.
Learn more →New furnace installation, sized and vented correctly for your home.
Learn more →Tell us what you need — we'll take a look and give you a straight answer.
